The battery polarity (+) and (-) shall not be connected and charged reversely. Please keep follow all listed important warnings and cautions below while using this battery pack to avoid any damage or hazard. “CAUTION!” Risk of explosion if battery pack is not replace by same type as specified by the manufacturer. This battery must not be disposed of with your other household waste or treat them in compliance with the local regulations or contact your local city office, your household waste disposal service or the shop where you purchased the product. This product must not be disposed of with your other household waste or treat them in compliance with the local regulations or contact your local city office, your household waste disposal service or the shop where you purchased the product. Maximum radio-frequency power transmitted in the frequency band(s) in which the radio equipment operates: Frequency band(s) in which the radio equipment operates: 2.400 – 2.4835 GHzī. We are fully committed to offering REACH compliance on the products and posting accurate REACH compliance status for the all of products.įrequency bands and Powers (Headset and Transceiver)Ī. hereby confirms, to date, based on the feedback from our suppliers indicates that our products shipping to the EU territory comply with REACH (Registration, Evaluation, Authorization, and Restriction of Chemicals 
The full text of the EU declaration of conformity is available at the following internet address:
declares that the equipment which is compliance with directive RoHS 2.0 (2015/863/EU), R.E.D (2014/53/EU), EMC Directive (2014/30/EU), and LVD (2014/35/EU) which are issued by the Commission of the European Community. Position the microphone close to the corner of your mouth with the flat surface facing you
You will hear a tone when the pairing is completed MICROPHONE. With the headset off, press and hold the power button 06 for 6 seconds. Initiate wireless dongle pairing from Engine. Connect the USB-C wireless dongle 10 to a Windows PC with SteelSeries Engine installed. Note: The headset is already paired with the transmitter out of the box OFF To power off the headset press and hold the power 06 button for at least 3 seconds PAIRING You will hear a tone, and the power LED 07 will illuminate. 
ON To power on the headset press and hold the power button 06 for at least 2 seconds. The color of the power LED 07 indicates the battery level. To charge the headset, connect the micro-USB charging cable 11 to the micro-USB jack 08 on the headset, and plug the other end into any USB power source.
0 kommentar(er)
